Uudet Fliegl DHKA 390 - 50 m³ kippipuoliperävaunu

Description: Tipper
Note: The trailer may only be pulled by tractor units that guarantee the effectiveness of the ABS!
axle configuration: 3 axles
Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications
Further Information
Chassis
Semi-Trailer
Tipper
Fine-grained steel welded construction
in basic lightweight design
turntable with interchangeable 2 kingpin
Curved front end
patented
24 tons
2-speed landing gear
single-sided operation
with straight lower part
without stroke compensation
2 support wedges with holder
Underrun protection
foldable
Half-shell fenders
Integrated fender holder
surface designed to repel stones
With anti-splash flaps
only on the last axle
1 tarpaulin rod with bracket
Axles + Suspension
BPW disc brake axles with 430 mm disc diameter
Axle/chassis laser-aligned to reduce tire wear and fuel consumption
1st axle
including forced lowering and starting aid
Hot-dip galvanized lift axle mechanism
10-year warranty against rust-through
Braking System
2-line compressed air braking system
color-coded lines for easy servicing
Spring brake parking brake
2 tamper-proof coupling heads at the front
without connection line
Electronic Braking System with EBS socket at the front
without connection cable
With lifting and lowering valve
Dcjblbn E Doi Ri Ihjhop
Vehicle – Driving Stability System
Wheels and Tires
385/65 R22.5
manufacturer’s choice
Steel rims
factory silver
"TPMS" Tire Pressure Monitoring System according to ECE R 141
display via the tractor unit’s display
via EBS
without installation in the truck (this must be available in the truck. Only on base tires)
Electrical System
24 Volt
multi-chamber lights
yellow LED lighting on the sides
Yellow LED lighting on the sides linked to the turn signal "flashing side lights"
2 white position lights at the front
2 white/red outline lights at the rear
2 x 7-pin tamper-proof sockets at the front
without connection cable
Low-pressure cylinder max. 170 bar
smallest stage hard-chromed
with HDK screw sleeve
fixed part
NW 48 mm (without hose connection)
Operated hydraulically via truck auxiliary drive
Tipping Body
Aluminum box tipper body made of high-quality
abrasion-resistant material
front wall 5 mm thick
with outer wall made of 30 mm hollow chamber profiles
neatly welded
with top edge profile that prevents material from spilling out. Inside with access ladder on the front wall (not in connection with Cramaro)
Shovel and broom holder on the outside of the front wall
Greenline – tapered and aerodynamic tipper body design
Membrane – rear wall
Rear wall with double-joint hinge
mounted to allow movement
with 2-part door division 1/2 to 1/2
at the top with a pivoting gantry
with one grain slide per door
Rear wall with rubber seal. Note! Heat resistant up to max. 170°C!
Floor consistently 6 mm thick
Standing platform with access ladder
connection plate for air/electrical and brake with large clearance for best possible operation
Roller cover
single-sided for depositing on the right-hand side
Approval Country/Signage
Germany
Type approval according to EC 2007/46
24/7 service hotline
Prepared for single-row license plate holder
Contour marking with reflective strips according to ECE R 048
white on the sides and red at the rear
Painting
Frame DB 7350 Novagra